Single Ply ColorGard Snow Fence Bracket
Aluminum bolt-down bracket and stainless steel base plate mount for Colorgard Bar-Style snow guard systems mounted on single-ply membrane roofs.
Roof Mounting Method:
- Base plate fastens into roof deck or sub-structure.
- Flashing membrane is applied over the base plate with upright bolts exposed.
- Colorgard mounting bracket is attached to exposed base plate bolts, ensuring a watertight seal.
Snow Retention System:
- Bar Style Snow Guards
Product Category:
Roof Type Category:
- Single Ply Membrane
Related Products
The S-5!® VersaClip™ makes installation of the ColorGard® Bar on standing-seam metal roofs easy. Simply slide onto the ColorGard® Bar and attach to appropriate S-5!® Clamps.
Aluminum / Stainless Steel
VersaBracket™ can be used to mount virtually anything to an exposed-fastened roof system and is compatible with almost any trapezoidal, exposed-fastened profile.
Aluminum
The S-5!® SnoClip™ is an aluminum add-on that helps retard the migration of snow and ice beneath the ColorGard® Bar. It has a special integrated rubber "foot" to prevent abrasion of the panel's finish.
Aluminum
Product Cut Sheet
Single Ply ColorGard Snow Fence Bracket Cut Sheet
Materials List:
Aluminum ColorGard w/ Stainless Steel Base Plate
Installation Instructions
Single Ply Colorgard Installation Instructions
Installation Instructions for Single Ply – Colorgard Bracket
The Single Ply – 2 Pipe snow fence bracket system is comprised of 3 parts.
1. Aluminum Colorgard Attachment Bracket
2. Target Flashing
3. Stainless Steel Base Plate
Instruction Steps:
1)
Installation of the Base Plate:
1. The Stainless Steel Base Plate is placed on top of the finished roof system and located as indicated on the snow retention plan provided by Rocky Mountain Snow Guards. Generally, the snow fence system will be 12” from the eave edge. The base plate is positioned with 3 attachment holes at the top.
2. The base plates are fastened into place with 5 fasteners of the type recommended for the specific job conditions. The Single Ply bracket is usually fastened into solid wood blocking on insulated roofing systems although fastening through wood decking is also acceptable provided there is no insulation between the decking and the membrane.
2)
Installation of the Target Flashing:
1. The Target Flashing must be of the same material as the roofing system.
2. Each Target Flashing should be a minimum of 12” x 12”.
3. Holes are cut through the Target Flashing to correspond with the upright studs on the Stainless SteelBase Plate.
4. Apply sealant around each upright stud and push flashing into place over the studs.
5. Heat seam, tape or glue the Target Flashing to the roof membrane as required by the membrane manufacturer.
3)
Installation of the Colorgard Attachment Bracket:
1. Slide the bracket over the upright studs.
2. Tighten the supplied Stainless Steel nuts.
Tools Needed
- Drill
- Appropriate Sealant
- Appropriate Fasteners