- PART 1-GENERAL
- SUMMARY
- WORK INCLUDES
- Drift II, III, III+ or IV - two, three or four pipe snow brackets.
- Provide appropriate snow bracket and snow bracket accessories for the roofing system.
- RELATED SECTIONS
- Section 07600 Flashings and Sheet Metal
- Section 7 Thermal and Moisture Protection
- WORK INCLUDES
- SYSTEM DESCRIPTION
- COMPONENTS
- Drift Series- bolt down snow fence brackets.
- Aluminum Tubing
- Tubing Couplers
- Tubing Caps
- Tubing Collars
- Ice Stops
- DESIGN REQUIREMENTS
- Bracket and row spacing to be determined by manufacturer or engineer.
- Structure must be able to withstand snow load held on roof.
- COMPONENTS
- SUBMITTAL
- Submit manufacturer’s specifications, detail drawings, recommended layout and installation instructions
- QUALITY ASSURANCE
- Installer to be experienced in the installation of roofing materials and snow retention products.
- DELIVERY, STORAGE AND HANDLING
- Material to be inspected upon delivery for damage and stored in a safe, dry location prior to installation.
- SUMMARY
- PART 2 – PRODUCTS
- MANUFACTURER
- Rocky Mountain Snow Guards, Inc. 2055 S. Raritan, Denver, CO 80223, (877) 414-7606, www.rockymountainsnowguards.com.
- MATERIALS
- Drift Series- snow fence brackets are extruded 6061-T6 aluminum.
- Tubing is 6061-T6 aluminum with 1” outside diameter and .0125 wall thickness.
- Tubing Couplers are 6061-T6 Aluminum shaft with stainless washers and tightening bolts, nylon slip
- washers and rubber expansion washers.
- Tubing Caps are 302 stainless steel
- Tubing Collars are 6061-T6 aluminum with stainless steel set screws.
- Ice Stops are 601-T6 aluminum with stainless fasteners.
- MATERIAL FINISH
- All materials are mill finish. Powder coating is available but not required as all parts are either aluminum or stainless steel.
- MANUFACTURER
- PART 3 – EXECUTION
- EXAMINATION
- Verify structure will accommodate ground snow loads and drifting loads present at the job site.
- Verify that attachment of the metal roofing panels will accommodate the loads incurred by the addition of the snow retention system
- INSTALLATION
- Follow architectural drawings or drawings supplied by manufacturer for location of snow brackets.
- Follow manufacturer’s installation instructions and layout guide.
- EXAMINATION
